Roller Gear Cam Drive Tilting Rotary Table
ø170
RCF-170S/H
Worktable diameter Ø170, Ø210, Ø255, Ø320.
Rolling contact reserves high rigidity, high speed and long endurance.
Least drive energy wear-out and more than 80% transmission rate.
Backlash-free from rolling motion achieves high accuracy.
- SPECIFICATIONS
Specifications
| MODEL | Unit | RCF-170S/H | ||
|---|---|---|---|---|
| Worktable Diameter | mm / inch | Ø170 / Ø6.69 | ||
| Center Bore Diameter | mm / inch | Ø40H7 / Ø1.57H7 | ||
| Height of Table (Horizontal) | mm / inch | 270 / 10.6 | ||
| Height of Center (Vertical) | mm / inch | 200 / 7.87 | ||
| Width of T-slot | mm / inch | 12H7 / 0.47H7 | ||
| Width of Guide Block | mm / inch | 18 / 0.71 | ||
| Clamping Method / Pressure | MPa / psi | P: 0.55~0.7 / 79.8~101.5 H: 2.5 / 363 |
||
| Servo Motor Spec | Refer to Page 78 | |||
| Transmission Ratio | R | T | ||
| 1 : 60 | 1 : 90 | |||
| Max. Table Speed / At Specified Servo Motor Speed | min-1 | 50 / 3000 | 33.3 / 3000 | |
| Clamping Torque | N.m / ft. lbs. | 300 / 221 600 / 443 |
400 / 295 700 / 516 |
|
| Allowable Loading Capacity | In Horizontal |
kg / lb | 75 / 165 | |
In Tilting (0~90°) |
kg / lb | 50 / 110 | ||
| Allowable Unbalancing Work Moment | WxL |
N.m / ft. lbs. | 40 / 29.5 | |
|
FxL When Table Clamped |
 F |
N / lbs. | 7000 / 1571 | |
 FxL |
N.m / ft. lbs. | 300 / 221 600 / 443 |
||
 FxL |
N.m / ft. lbs. | 400 / 295 700 / 516 |
||
| Standard Loading Inertia | (W.D2/8) |
kg.m2 | 0.2 | |
| Resolution | deg. | 0.001 | ||
| Indexing Accuracy | sec | 20 | 60 | |
| Repeatability | sec | 6 | 8 | |
| Tilting Angle Range | deg. | -30 ~ +120 | ||
| Net Weight (Servo Motor Excluded) | kg / lb | 221 / 487 | ||
| Cam Allowable Torque | N.m / ft. lbs. | 280 / 207 | ||
| Allowable Max. Rotary Joint Quantity | Port | 4 | ||
Note:
1. R: Rotary Axis T: Tilt Axis
2. FxL When table clamped is a reference data, the users should consider proper safety factor or contact detron for details.
1. R: Rotary Axis T: Tilt Axis
2. FxL When table clamped is a reference data, the users should consider proper safety factor or contact detron for details.
